Publicidad
Idiomas disponibles
Idiomas disponibles
Safety / Initial use / Changing the light bulb
Do not install the lamp on a wet or conductive
surface.
Only insert the light bulb in a dry
environment.
This lamp is not suitable for external
dimmers and electronic switches.
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the illuminant from a close
distance during operation.
Do not use optical instruments to look at the
illuminant.
In order to disconnect the light completely from
the power supply, the mains plug must be
removed from the socket.
Only use the light bulbs specified in the chapter
"Technical data".
Initial use
Mounting the lamp
Note: Remove all packaging materials from the
product.
Only 14135306L:
Caution: The lamp glass
are pre-assembled, but are not screwed tight.
1
Loosen the ring nut
Bring the lamp glass
(see Fig. A).
Only 14135402L:
Loosen the ring nut
Bring the lamp glass
(see Fig. B).
14 GB/IE
and the ring nut
2
from the lamp socket
1
into the correct position
2
from the lamp socket
1
into the correct position
2
All models:
Screw the lamp glass
Be sure they are positioned correctly.
Use a clean, lint-free, dry cloth to insert the
bulb
.
5
Screw the light bulb
socket
.
3
Plug the mains plug
socket.
Your light is now ready to use.
Switching the light on / off
Touch the lamp base
or off.
Dimming the lamp
Note: The lamp is only dimmable using the light
bulb
supplied.
5
To dim the light bulb
multiple times in short succession.
Each time the lamp base (touch dimmer) is
touched, the lamp is then briefly switched off.
The next dimming level then follows.
If the dimmer function was interrupted for a
while (approx. 10 seconds) between the sepa-
rate levels, the brightest light level will always
be switched on.
Changing the light bulb
Switch the lamp off.
.
First unplug the mains plug
3
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the lamp to cool down completely.
Use a clean, lint-free, dry cloth when replacing
.
the illuminant
3
Unscrew the defective illuminant
lamp socket
to the ring nut
2
clockwise into the lamp
5
into a properly installed
4
to switch the lamp on
6
touch the lamp base
5
RISK OF ELECTRIC SHOCK!
from the socket.
4
.
5
from the
5
, turning counter-clockwise.
3
.
1
6
Publicidad
