Connections - Macrom 43.05 Manual De Instrucciones

CONNECTIONS

1. Battery lead: Connect the BATT-terminal
adequate section.
Do not connect this lead to circuits existing within the electric system of the car. In order to avoid
damage to the car it is imperative that this lead be fitted with a fuse (not provided) as near as
possible to the car's battery. This connection is the to be carried out last.
2. Remote switch-on lead: Connect the (REMOTE) switch-on lead or the control lead of the
power antenna coming from the head unit (blue) to the REMOTE terminal
NOTE: In case this lead is not connected, the amplifier will not be switched on when the head
unit is switched on. If your head unit is not fitted with an output connector for a power antenna,
a quick-break lever switch (SPST) shall be installed between the power source (+12 V) and the
remote switch-on lead and connected to the REMOTE terminal
switch-on of the amplifier.
3. Ground lead: Connect a ground lead (black) of adequate section to a clean spot on the car
chassis and to the GND terminal
electric continuity between this spot and the negative terminal of the battery. Use a ground cable
as short as possible, and in case more than one amplifier are used connect all ground leads to
the same spot.
4. FUSE: In case of fuse replacement make sure to replace them with fuses of the same
amperage. The use of fuses with the wrong amperage may seriously damage the components
of the unit.
5. Speaker output terminals: Make sure to keep the right polarity and phase in connecting the
speakers. This includes the control of the right polarity, (+ and -).
NOTE: Never connect the negative wires to each other and never use a common negative lead
for all the speaker.
Take care that inadequately isolated wires do not come into contact with the the ground, metallic
parts of the car or with each other.
3-channel configuration
MONO
+ C
+ A +
LEFT RIGHT
6. RCA-type input connectors: Connect the Pre output leads of your head unit to the RCA-type
input connectors by means of RCA extension cables (e.g. 90.05-90.10-90.25-90.50 by
MACROM).
Make sure to respect the right channel designation: left L (white) and right R (red).
CONNECTIONS
. Make sure that the connection is sound and that there is
12
2-channel configuration
+
B
+
LEFT
directly to the car's battery with a yellow lead of
11
C
A + B
RIGHT
8
of the amplifier.
13
so as to provide for manual
13
1-channel configuration
MONO
+ C
+ A + B