Publicidad
Compliance Information
FCC Compliance Notice
Supplier's Declaration of Conformity
Product name: DJI Focus Pro Hand Unit
Model Number: DF03-004
Responsible Party: DJI Research LLC
Responsible Party Address: 17301 Edwards Road,
Cerritos, CA 90703
Website: www.dji.com
We, DJI Research LLC, being the responsible party,
declares that the above mentioned model was tested
to demonstrate complying with all applicable FCC
rules and regulations.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment
and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV
technician for help.
RF Exposure Information
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. End user must follow the specific
operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located
or operating in conjunction with any other antenna
or transmitter.
The portable device is designed to meet the
requirements for exposure to radio waves
established by the Federal Communications
Commission (USA).
These requirements set a SAR limit of 4 W/kg
averaged over ten gram of tissue. The highest SAR
value reported under this standard during product
certification for use when properly worn on the
limbs.
ISED Compliance Notice
CAN ICES-003 (B) / NMB-003(B)
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two
conditions: (1)This device may not cause interference.
(2)This device must accept any interference, including
interference that may cause undesired operation of
the device.
L'émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux
CNR d'Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes :(1)L'appareil ne doit pas
produire de brouillage; (2)L'appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with RSS-102 radiation
exposure limits set forth for an uncontrolled
environment. End user must follow the specific
operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located
or operating in conjunction with any other antenna
or transmitter.The portable device is designed to
meet the requirements for exposure to radio waves
established by the RSS-102.
Cet équipement est conforme aux limites d'exposition
aux rayonnements CNR-102 établies pour un
environnement non contrôlé. L'utilisateur final doit
suivre les instructions spécifiques pour satisfaire les
normes. Cet émetteur ne doit pas être co-implanté
ou fonctionner en conjonction avec toute autre
antenne ou transmetteur. Le dispositif portatif est
conçu pour répondre aux exigences d'exposition
aux ondes radio établie par le développement
énergétique DURABLE.
These requirements set a SAR limit of 1.6 W/kg
averaged over one gram of tissue. The highest SAR
value reported under this standard during product
certification for use when properly worn on the body.
Ces exigences un SAR limite de 1,6 W/kg en moyenne
pour u. La valeur SAR la plus élevée signalée en vertu
de cette norme lors de la certification de produit à
utiliser lorsqu'il est correctement porté sur le corps.
部件
铅
汞
名称
(Pb)
(Hg)
(Cd)
线路板
×
○
外壳
×
○
液晶屏
×
○
（如有）
金属部件
×
○
（铜合金）
内部
×
○
线材
其他
×
○
配件
本表格依据 SJ/T 11364 的规定编制。
○：表示该有害物质在该部件所有均质材料中的含量均在
GB/T 26572 规定的限量要求以下。
×：表示该有害物质至少在该部件的某一均质材料中的
含量超出 GB/T 26572 规定的限量要求。（产品符合欧盟
ROHS 指令环保要求）
KC Compliance Notice
"해당무선설비는 운용 중 전파혼신 가능성이 있으므로 인
명안전과 관련된 서비스는 할 수 없습니다 ."
"해당 무선설비는 운용 중 전파혼신 가능성이 있음"
NCC Compliance Notice
取得審驗證明 Compliance Notice 之低功率射頻器材，
非經核准，公司、商號或使用者均不得擅自變更頻率、
加大功率或變更原設計之特性及功能。低功率射頻器材
之使用不得影響飛航安全及干擾合法通信；經發現有干
擾現象時， 應立即停用， 並改善至無干擾時方得繼續使用。
前述合法通信，指依電信管理法規定作業之無線電通信。
低功率射頻器材須忍受合法通信或工業、科學及醫療用
電波輻射性電機設備之干擾。
使用過度恐傷害視力
注意事項：
（1）使用 30 分鐘請休息 10 分鐘。
（2）未滿 2 歲幼兒不看螢幕，2 歲以上每天看螢幕不要
超過 1 小時。
EU & UK Compliance Notice
EU Compliance Statement: SZ DJI Osmo Technology
Co., Ltd. hereby declares that this device (DJI Focus
Pro Hand Unit) is in compliance with the essential
requirements and other relevant provisions of the
Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available
online at www.dji.com/euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12,
97618, Niederlauer, Germany
GB Compliance Statement: SZ DJI Osmo Technology
Co., Ltd. hereby declares that this device (DJI Focus
Pro Hand Unit) is in compliance with the essential
requirements and other relevant provisions of Radio
Equipment Regulations 2017.
A copy of the GB Declaration of Conformity is available
online at www.dji.com/euro-compliance
Declaración de cumplimiento UE: SZ DJI Osmo
Technology Co., Ltd. por la presente declara que
este dispositivo (DJI Focus Pro Hand Unit) cumple los
requisitos básicos y el resto de provisiones relevantes
de la Directiva 2014/53/EU.
Hay disponible online una copia de la Declaración de
conformidad UE en www.dji.com/euro-compliance
Dirección de contacto de la UE: DJI GmbH,
Industriestrasse 12, 97618, Niederlauer, Germany
EU-verklaring van overeenstemming: SZ DJI Osmo
Technology Co., Ltd. verklaart hierbij dat dit apparaat
(DJI Focus Pro Hand Unit) voldoet aan de essentiële
vereisten en andere relevante bepalingen van Richtlijn
2014/53/EU.
De EU-verklaring van overeenstemming is online
beschikbaar op www.dji.com/euro-compliance
Contactadres EU: DJI GmbH, Industriestrasse 12,
97618, Niederlauer, Germany
Declaração de conformidade da UE: A SZ DJI Osmo
Technology Co., Ltd. declara, através deste documento,
que este dispositivo (DJI Focus Pro Hand Unit) está em
有害物质
镉
六价铬
多溴联苯
+6
(Cr
)
(PBB)
醚 (PBDE)
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
多溴二苯
○
○
○
○
○
○
Publicidad
