Publicidad
Idiomas disponibles
Idiomas disponibles
gate configurations (choose which best fits your scenario):
Measure the width of the opening where you intend to install the gate.
• Refer to the following illustrations to determine the correct installation
configuration.
• Baseboard molding may change which configuration is appropriate.
A
(29 in.- 32 in.) without extension frames
C
(37 in.- 40 in.) with one long extension frame
E
(45 in.- 48 in.) with both short and the long extension frames
Note: This instruction book illustrates installation of gate configuration E.
• If choosing gate configuration A, skip step 4.
• If choosing gate configuration B, add only one short gate extension to either side
of the gate frame in step 4.
• If choosing gate configuration C, add only the large gate extension to either side
of the gate frame in step 4.
• If choosing gate configuration D, add only one short gate extension and the long
extension to either side of the gate frame in step 4.
B
(33 in.- 36 in.) with one short extension frame
D
(41 in.- 44 in.) with one short and the long extension frames
WARNING
NEVER install three extension
frames on the same side of the
gate.
IMPORTANT:
Gate includes a door stop (part F in
components) which prevents the gate
from swinging open in one direction.
• When installing the gate at the top of
stairs, be sure the door stop is on the
stairway side of the gate so the door
cannot open over the stairs.
• While the door stop comes fully
assembled on gate, it can be removed
and installed on either side of gate frame.
• When gate is not used at top of stairs,
door stop may be removed to allow gate
door to open in either direction.
3
Publicidad
