Electrolux EXP09HN1WI Manual De Instrucciones página 11

6. To secure lower sash in place, attach
right angle sash lock with 1/2"
(12.7mm) screw as shown (Fig. 16).
NOTE: It is difficult to lock the windows
with the sash lock for Vinyl-Clad
windows, so you can use lock by
window itself.
7. Cut the foam seal to an appropriate
length and seal the open gap between
the top window sash and outer window
sash, as shown in Fig.17.
Fig. 16
Foam seal
Fig. 17
4.4 Installation in a sliding sash
window
1. Cut the foam seals (adhesive type) to
the proper lengths and attach them to
the window frame. See Fig.18.
Foam seal A
(adhesive type)
Fig. 18
2. Open the window sash and place the
window slider kit on the window stool.
See Fig.19. Attach the window slider kit
to the window stool. Adjust the length
of the window slider kit according to the
height of window. Screw down the two
screws on the window slider kit. See
Fig.19. Cut the adjustable window slider
kit if the height of window is less than
26.6 inches (Fig. 14).
Window stool Window slider kit
26.6"~48.5"
Fig. 19
3. Close the sliding sash securely against
the window slider kit. (Fig. 20)
4. Drive two 1/2" screws to secure the
window slider kit to the window sash.
(Fig. 20)
5. Drive two 3/4" screws to secure the
window slider kit to the window stool.
(Fig. 20)
Window stool
3/4" screws
Fig. 20
6. Cut the foam seal to an appropriate
length and seal the open gap between
the sliding sash and outer window sash,
as shown in Fig.21.
7. To secure the sliding sash in place,
attach right angle sash lock with 1/2"
(12.7mm) screw as shown (Fig.22).
Fig. 21
Fig. 22
ENGLISH 11
screws
Window slider kit
1/2" screws
Foam seal