EINHELL TP-MA 36/30 Li BL Manual De Instrucciones Original página 18

Important! Thoroughly clean all the spacers and
fl anges.
Fitting:
Important! Diamond cutting wheels must always
be replaced as pairs!
•
Fit the bottom inner flange (f) and the bottom
cutting wheel (e)
Important! Check the direction of rotation of
the cutting wheel!
•
Fit the number of spacers (d) required for the
groove width
•
Place the top inner flange (c) – with its raised
side up – onto the last fitted spacer.
Important! Each spacer is approx. 3.5 mm
wide. The groove width results from the
number of spacers (d), the top inner flange
(c) between the cutting wheels, and the thick-
ness of the two cutting wheels
•
Put on the top cutting wheel (b)
Important! Check the direction of rotation of
the cutting wheel!
•
Fit any spacers (d) that might still be left over,
reattach the outer flange (a), and screw the
socket head screw (h) back in place.
Warning! All 6 spacers (d) must be fi tted
irrespective of the desired groove width!
Close and fasten the fl ange cover (12) and swivel
the depth stop (7) back in place.
Fasten the depth stop (7) using the locking screw
for depth screw (6).
Important! Check that all the parts are seated
fi rmly and correctly.
Caution:
Only ever press the spindle lock when
the motor and grinding spindle are at a
standstill! The spindle lock must be kept
pressed while the wheel is being changed!
6.5 Motor
It is vital for the motor to be well ventilated during
operation. Be sure, therefore, to keep the ventilati-
on holes clean at all times.
Anl_TP-MA_36-30_Li_BL_SPK13.indb 18 Anl_TP-MA_36-30_Li_BL_SPK13.indb 18
GB
6.6 Working with the masonry channel cutter
(Fig. 12)
The device is fi tted with an overload cut-out. The
motor will cut out if overloaded. Relieve the load
on the motor immediately and allow the masonry
channel cutter to cool down for approx. 1 minute
without load.
Danger! The device is suitable for dry cutting
only!
•
Use a cable/pipe detector to check for conce-
aled electric cables and gas and water pipes
in the wall before you start using the masonry
channel cutter.
•
Select the desired groove width (see 6.4) and
groove depth (see 5.1).
Only ever guide the device along the workpiece
while switched on.
•
Place the device against the wall with the rol-
ler (10) against the wall.
•
Switch on the device and then cut slowly into
the wall until the stop (7) rests against the
wall.
•
Now you can cut the groove in the wall. Take
care with the cutting direction (a) as you do
so. The device must always be handled on
a counterrotating basis otherwise there is a
risk that it may be forced out of the cut in an
uncontrolled manner.
Caution! Cut in a straight line only. It is not
possible to cut curves.
•
At the end of the groove, swing the device out
of the groove before you switch it off.
•
You can then cut out the ridge between the
two grooves with a chisel.
Important! It is prohibited to use this
equipment on materials containing asbestos!
- 18 -
29.05.2024 08:37:21 29.05.2024 08:37:21