Bergeon SA
2400 Le Locle / Suisse
3
1
1. Power supply:
Tél. +41 32 933 60 00
www.bergeon.ch
Fax +41 32 933 60 01
info@bergeon.ch
4
This device is equipped with an adjustable potentiometer, going from 20°C to 140° C with
1
the linear cursor
Connect the cable to the device.
The device gets under tension with to the switch on/off button
As soon as switched on, the LED
perature. As soon as reached, the LED
Increasing the temperature, the LED
the wished temperature.
When the temperature is set over 40 °C the LEDs
out, that the device has reached a high temperature and that the surface must not be held
anymore, because there is a serious risk of burning.
As long as the temperature is above 40° C, the two LED's will blink continuously.
The side parts of the heating surface are not heat conducting and allow a handling or
moving without risk of burning.
By switching off the device, the LED
long as the temperature doesn't sink below 40 °C.
They then light out to indicate, that there isn't any risk of burning any more.
6
2
.
3
starts blinking in green until reaching the given tem-
3
stops blinking.
3
first turns red, then green again, as soon as reached
3
will wipe out, the LEDs
Description
1
Cursor
2
On/off switch
3
Reached temperature indicator
4
High temperature indicator
5
High temperature indicator (behind)
6
Heating surface
5
2
.
4
5
and
(on the back cover) to point
4
and
5
stay lighted, as