Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 2C
CAUTION:
Avoid potential personal injury or
property damage!
● Studs must be at least 2x4 / 25 ga.
● If back side of wall is unfinished, drywall must be installed to
a minimum of one stud left and right
of the stud(s) being used to install the mount
● Drywall must be a minimum of 1/2 in. (13 mm) thick on
each side of the studs, and a minimum clearance of 1
⅞ in. (48 mm)
behind the wall is required
● This product must be centered on the studs
● Stud type and structural strength must conform to the North
American Specification for the Design of Cold-Formed Steel
Structural Members
[362 S 125 18, C-Shape, S - Stud Section]
● Drywall must be secured to studs with screws
12 in. (304.8 mm) on center
4
POSITION TEMPLATE
06
To calculate your precise wall plate location, check out our Height
TIP:
Finder at sanus.com [www.san.us/1172].
6
INSTALL ANCHORS
a
S1
c
P
S1
CAUTION:
Be sure cap
seated against the drywall surface.
8
Steel Stud Installation
Steel Stud Installation Kit SSMK1 (NOT INCLUDED)
Contact Customer Service to inquire about the additional hardware.
1/4-20 SNAP Toggle BB
1
HeightFinder™
san.us/1172
b
S1
d
S1
is
P
x4
S2
S1
x4
1/4-20 x 1 ¾ in.
LOCATE
5
DRILL
Visit
www.
4X
CAUTION:
7
SECURELY TIGHTEN
07
Open
covers
CAUTION:
Avoid potential personal injury or property damage!
Do not over-tighten the lag bolts
against the wall plate
.
07
x4
S3
1/4 in.
2
VERIFY
06
Be sure you drill into the CENTER of the stud.
4X
S3
S2
. Tighten the lag bolts only until they are pulled firmly
S2
Min. 16 in. (40.6 cm)
3
MARK
1 in. (25 mm)
1/2 in.
(13 mm)
Close
bottom
cover
Publicidad
