Publicidad
Idiomas disponibles
Idiomas disponibles
Caution! Before troubleshooting, disconnect the power supply. Only a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance dose not work
Appliance freezes too
much
The food is not frozen
enough
Heavy build-up of frost
on the door seal.
Unusual noises
If the malfunction shows again,contact the Service Center.
These data are necessary to help you quiskly and correctly.Write the necessary data here, refer to
therating plate.
Possible cause
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or the
appliance runs at "7" setting.
Temperature
is
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, in the side
of the appliance istouching another
part of the appliance or the wall.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected
by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
not
properly
Please look in the initial Temperature
Setting section.
Open the door only as long as necessary.
Turn the temperature regulation to a
colder setting temporarily.
Please look in the installation location
section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a cool
setting). At the sametime shape the
warmed door seal by hand such that it
sits correctly.
Check the appliance and level it by some
articles.
Move the appliance slightly.
If
necessary,
component out of the way.
17
Solution
carefully
bend
the
Publicidad
