Description - Hilti TE 7-C Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Chiseling Chisel
position
adjustment

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer with pneumatic hammering mechanism.
The power tools are designed for drilling in concrete, masonry, gypsum board (drywall), wood, plastic and metal. The
power tool can also be used for light chiseling work on masonry and surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use. The power tool may be operated, serviced and repaired only by
authorized, trained personnel. This personnel must be informed of any special hazards that may be encountered.
The power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Changes or modifications to the power tool are not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2.2 Chucks
TE‑C CLICK chuck
2.3 Switches
Speed control switch for smooth starting.
Function selector switch:
14
Wear ear
hat protection
Drilling
without
hammering
Volts
Watts
Wear
protective
gloves
Revolutions
per minute
Forward
rotation
Location of identification data on the power tool
Hammer
The type designation can be found on the type identifica-
drilling
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Type:
Amps
Serial no.:
Alternating Hertz
current
Diameter Double
insulated
Rated speed
under no
load
Reverse
rotation