Publicidad
Idiomas disponibles
Idiomas disponibles
Pause Mode
Pause mode lasts for 2 minutes. The strength LEDs
light to indicate the time remaining.
3 solid, 1 flashing
2 solid, 1 flashing
1 solid, 1 flashing
1 flashing
•
Press and hold the mix button for 3 seconds to cancel
pause mode.
•
If the LED countdown finishes before the drink mixing
resumes or pause mode is cancelled, the unit will pump
a small amount of water to flush the lines. The cocktail
maker will reset to its original mode and the drink will
no longer be mixed. If there is no water loaded into the
cocktail maker, the unit will flush the lines with air.
nOTE: The unit will not flush the lines while the capsule
holder lid
22
is lifted.
Pause mode is triggered three ways.
•
The mix button is pressed.
‑
Press the mix button once more to resume.
•
The capsule holder lid is open.
‑
Close the lid and press the mix button.
•
A bottle runs out of liquid
‑
Replace the empty bottle as described in the BOTTLE
RUNS OUT DURING MIXING section.
Turn on Party Mode LEDs (Fig. K)
The bottle LEDs
16
can be set to flash in a preset pattern.
1. Turn the cocktail maker on by pushing the "I" side of the
power switch
14
. All 6 bottle LEDs will light.
2. Press the party mode button
The LEDs will begin flashing.
3. Press the party mode button a second time to turn all
bottle LEDs off..
4. Press the party mode button a third time to turn all bottle
LEDs back on.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and keep away from power
switch before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
Your BLACK+DECKER appliance has been designed to
operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends
upon proper appliance care and regular cleaning.
Cleaning (Fig. C)
WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
appliance. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
15
will
1:30 ‑ 2 min. remaining
1 ‑ 1:30 min. remaining
30 sec. ‑ 1 minute remaining
less than 30 sec.
27
once to set party mode.
inside the appliance; never immerse any part of the
appliance into a liquid.
CAUTION: Straws, bottle stoppers, capsule cup, drip
tray cover, and water bottle are top‑rack dishwasher
safe. It is recommended that you manually rinse the
attachments before placing them in the dishwasher.
•
Clean the inside of the straws with warm water, mild
soap, and the provided straw cleaner
•
Clean all external parts with a cloth dampened with warm
water and mild soap.
•
Remove the capsule cup
the capsule holder
21
the capsule holder and press down. Ensure the cup sits
fully and securely inside the capsule holder.
Cleaning Mode (Fig. E, I, L, M
It is recommended to clean the liquid lines of the cocktail
maker at least once a month.
1. Remove the capsule
Ensure the capsule cup
2. Place a large glass that holds at least 10 oz (300 ml) on
the drip tray
3
.
3. Remove the bottles as described in the REMOVING
BOTTLES section.
4. Fill a glass with at least 2 oz (60 ml) of water.
5. Place a straw
7
in the glass and install the straw as
described in the INSTALLING BOTTLES section.
6. Repeat steps 1 ‑ 5 for all bottles.
7. Press the cleaning mode button
8. Once the unit starts pumping water, let go of the
cleaning mode button.
9. The bottle LEDs
16
will light one at a time to indicate
which line is being cleaned. Once all LEDs turn on, the
process is complete.
10. Water may splash on the barcode scanner
a clean, dry towel to wipe the barcode scanner and
surrounding area.
11. Install the bottles as described in the INSTALLING
BOTTLES section.
Accessories
WARNING: Since accessories, other than those offered
by BLACK+DECKER, have not been tested with this
product, use of such accessories with this product
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your product
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact BLACK+DECKER call
1‑800‑544‑6986.
Storage
•
Clean out the liquid lines as described in the CLEANING
MODE section.
•
Switch off the appliance.
30
.
23
by pulling it up and out of
. To reinstall the cup, slide it into
20
from the capsule holder
23
remains in place.
for 6 seconds.
28
31
English
21
.
. Use
7
Publicidad
