Publicidad
STEP 15
IMPORTANT! THE BACK PANEL IS A STRUCTURAL PART OF THIS UNIT AND MUST BE INSTALLED PROPERLY.
With the help of another person, turn the unit over on its front side. Positon back panel as shown.
Align squarely with outer edges. Attach back panel to rear legs (H&I) with screws (5) but do not
tighten. Flush bottom edge of back panel with bottom edge of the bottom and nail straight into
back edges of top (D) and bottom (E). Now tighten the screws (5).
Notch in back panel for safety
bracket located here.
3
Assure that the unit is square.
Distance from corner to corner
must be equal as shown.
3
(x23)
#A21110
N
I
5
(x14)
#A12120
"Finished Surface"
E
Make sure edge of back panel is
flush with bottom edge of the
bottom.
23
5
H
Publicidad
