15. POWER button
16. Pressure hose connection
17. Clamping lever
18. LED signalling ring
19. CAR settings button
20. SUV settings button
21. Display
22. Pressure unit indicator
23. Change unit button
24. Increase pressure button
25. Pressure relief button
26. Start/Stop
02. ACTION
SEE FIGS. A-G
1. Charging the battery
Before using the device wirelessly for the first time, it is necessary to
charge the built-in battery. To do this, connect the supplied USB-C cable
with one side to the device and the other to a power adapter or other
device (e.g. computer, powerbank, etc. with 5V 2A). The battery charge
level can be monitored by means of the LED indicator (3).
ATTENTION: it is only possible to use one power source for the com-
pressor: a USB-C or 12V charger. Do not connect two power sources at
the same time, as you risk damaging the equipment.
2. First use
Place the product on a horizontal surface that is not flammable. Depend-
ing on the object to be inflated, you can use the connection valve (10)
directly or together with one of the included valve adapters (4-7). For
objects that are already pressurised (e.g. a partially inflated car tyre), it is
recommended to switch on the product before connecting the valve (10)
to the tyre. The maximum time for continuous operation of the device is
15 minutes, to prevent overheating and damage after this time it should
be allowed to cool down for a minimum of 10 minutes.
3. Power supply from 12V cigarette lighter socket
The compressor has the option of an alternative power supply for a dis-
charged battery, for example, via the 12V cigarette lighter socket. Insert
the power plug (9) into the unit's power connector (13), then connect
the cigarette lighter socket plug (8) into the 12V car socket.
NOTE: Before use, check the cigarette lighter socket to ensure that your
vehicle is fitted with the correct fuse rating. When using the alternative
power supply, start the engine to protect the vehicle battery.
4. Installation and removal of the pressure hose and adapters
10