Maintenance Of Freezer; 1 Cleaning; 2 Defrost; 3 Stop Using - EAS ELECTRIC EMCF101 Manual De Instrucciones

3 Maintenance of freezer

3.1 Cleaning

Dusts behind the freezer and on the ground shall be timely
cleaned to improve the cooling effect and energy saving.
Check the door gasket regularly to make sure there are no debris.
Clean the door gasket with a soft cloth dampened with soapy water
or diluted detergent.
The interior of the freezer should be cleaned regularly to avoid odor.
Please turn off the power before cleaning, remove all food, basket,
container,etc.
Use a soft cloth or sponge to clean the inside of the freezer, with
two tablespoons of baking soda and a quart of warm water. Then
rinse with water and wipe clean. After cleaning, open the door and
let it dry naturally before turning on the power.
For areas that are difficult to clean in the freezer such as gaps or corners), it is recommended to wipe
them regularly with a soft rag, soft brush, etc. and when necessary, combined with some auxiliary tools
(such as t hin sticks) to ensure no contaminants or bacterials accumulation in these areas.
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors
in the interior of the freezer or contaminated food.
Clean the baskets with a soft cloth dampened with soapy water or diluted detergent.
Dry with a soft cloth or dry naturally.
Wipe the outer surface of the freezer with a soft cloth dampened with soapy water, detergent, etc., and
then wipe dry.
Do not use hard brushes, clean steel balls, wire brushes, abrasives(such as toothpastes), organic
solvents (such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline items, which may
damage the freezer surface and interior. Boiling water and organic solvents such as benzene may
deform or damage plastic parts.
Do not rinse directly with water or other liquids during cleaning to avoid short
circuits or affect electrical insulation after immersion.

3.2 Defrost

Freezer shall be manually defrosted.
Unplug the freezer and open the freezer door, remove foods and s helving basket before defrosting;
Open the outflow hole and drainage hole (and place water container at the outflow hole;
indoor frost will naturally melt, wipe the defrost water with a dry, soft cloth. When the frost softens,
an ice scraper might be used to the accelerate de-icing process.
Please remove the food and put in a cool place when defrosting before removing accessories.
Other mechanical devices or other means shall not be used to accelerate
except those recommended by the manufacturer. Do not damage the
refrigerant circuit.

3.3 Stop using

Power failure:Foods can be preserved for a couple of hours even in summer in case of power failure;
it is recommended to reduce the frequency of opening door and do not put fresh foods into the freezer.
Long-time nonuse:Please unplug the freezer left unused for a long time for cleaning.
Keep the door open to avoid the bad odor.
Moving:Do not turn upside or vibrate the freezer, the carrying angle can not be greater than 45°.
Do not hold the door and hinge when moving this unit.
Please unplug the
Continuous operation is recommended when the freezer is
started. Please do not stop the freezer under normal
circumstances so as not to affect the freezer's service life.
freezer for defrost and cleaning.
9 V.1