Troubleshooting - Maytag SAV-4 HD Instrucciones De Uso

Ocultar thumbs Ver también para SAV-4 HD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
Won't Fill
Won't Agitate
Won't Spin or Drain
Load is Wet
Stops
Leaks Water
Is Noisy
Plug cord into live electrical
outlet.
Check fuse or reset circuit breaker.
Turn the control knob to proper cycle and pull knob out to start the washer.
Turn both faucets on fully.
Straighten
inlet hoses.
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Check fuse or reset circuit breaker.
Make sure the lid is completely
closed.
Turn the control knob to proper cycle and pull knob out to start the washer.
Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless the lid is closed.
Pauses are normal. Wait and see if the washer will start again.
Check fuse or reset circuit breaker.
Straighten
drain hoses. Eliminate kinked hoses. If there is a home drain restriction,
call for drain service.
Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless the lid is closed.
If drain height is over 15 feet, water may not be completely
removed.
Suds lock - caused by too much suds. Rewash without
detergent.
Use correct
amount of a low-sudsing
detergent.
• Unevenly distributed
load. Redistribute
the load, close the lid and pull knob out.
Check for leveling. Be sure water level is acceptable
for load size.
• A fast spin speed is recommended
for heavy loads like jeans or towels, or if the
drain height is over six feet.
• Plug cord into live electrical
outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless lid is closed.
This may be a pause or soak period in the cycle. Wait briefly and it may start.
Make sure hose connections
are tight.
Make sure end of drain hose is correctly inserted and secured to drain facility.
Avoid extended soaking - soak for 30 minutes or less.
Avoid overloading.
Be sure washer is leveled properly as outlined
in installation
manual.
Weak floors can cause vibration
and walking.
Be sure rubber feet are installed on leveling legs.
Operating
sounds will vary depending
on agitation speed.

Publicidad

Tabla de contenido
loading

Tabla de contenido