Publicidad
NOTE: The control system is equipped with a learning frequency function which has 16 code combinations to
prevent potential interference from other remote units. The frequency on your Receiver and Transmitter units
have been preset at the factory. No frequency change is necessary.
If the fan is non-functional or if you desire to install another fan within the same home or area with a separate
frequency code, please see this "learning process" section of this instruction manual to code-paring the
receiver and transmitter.
Learning process
Turn the power off to your ceiling fan.
Please use a small size tool to change the frequency settings on the transmitter.
Return power to the unit.
Within 60 seconds of turning the fan's AC power ON, press and hold the FAN OFF "
" button for 10 seconds
to enter the learning function.
NOTE: After the AC power is on, do not press any other button on the remote control before pressing the FAN
OFF "
" button. Doing so will cause the procedure to fail.
Once the receiver has detected the set frequency, the fan will begin to rotate for a short period and then shut
off. And if the fan is with light, the light will blink twice.
The receiver has now learn the frequency which has been selected on the transmitter. After completing the
steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the
transmitter. please turn the power off to the receiver, and repeat the process.
Publicidad
