Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTION MANUAL
DALTON
REF. A19364009S
A - WALL INSTALLATION
Depth
60MM
1
20°
10°
3
GENERAL SAFETY INFORMATION
_____________________________________________________________________________
>
To reduce the risk of death, personal injury, fire, electric shock,
falling parts, cuts / burns and other hazards, read all warnings and
instructions included with the appliance box as well as all labels.
>
Before installing or maintaining this equipment, follow the
instructions in this manual. For a residential installation, if you
are unsure whether to install or maintain the luminaire, consult a
licensed and qualified technician.
>
DO NOT INSTALL THE PRODUCT IF THE SAME IS DAMAGED
>
To prevent injury or damage to the assembly of this product, make
sure the conductors and screws are secure before connecting the
power.
>
Young children should be supervised to ensure that they do not
play with this product.
>
Handle the installation carefully to avoid any damage or breakage.
>
For installation, select an appropriate location away from liquids
and hazards. Make sure that the connection does not come into
contact with corrosive materials or surfaces, chemicals, etc.
>
Turn off the power and let it cool before cleaning. To clean, use a
clean, damp cloth. Never immerse the appliance in water.
>
Lamp replacement and maintenance: disconnect power and allow
fitting to cool down before cleaning or replacing.
>
Check that the supply voltage is correct compared to the
informative label of the luminaire.
A - INSTALLATION INSTRUCTIONS - WALL
_____________________________________________________________________________
①
Prepare the lamp, accessories and tools.
②
Drill two Φ14mm holes with a depth of 60mm in the wall and a
distance between holes of 104mm.
③
Fix the bushings in the holes.
④
Then use a wrench to fix the lamp to the wall with anchors. If
necessary, loosen the screws to adjust the angle of the luminaire
between 20º and 10º. Make sure the 4 base screws are tight.
B - STRAIGHT POLE INSTALLATION
U-shpaed Bracket
2
4
C - CURVED POLE INSTALLATION
20°
10°
B - INSTALLATION INSTRUCTIONS - STRAIGHT POST_________________
____________________________________________________________
①
Prepare the lamp, accessories and tools.
②
Remove the spacer nut from the U-shaped brackets.(Fig. 1)
③
Use the U-shaped brackets to fix the lamp on the pole. (Figure 2)
④
Loosen the screws at both ends of the bracket and adjust the
angle of the fixture as needed, which is 20° clockwise adjustable and
10° counterclockwise adjustable, and tighten the screws. (Figure 3
and 4)
*This installation applies to poles with a diameter of Φ50-60mm.
C - INSTALLATION INSTRUCTIONS - CURVED POST
_____________________________________________________________________________
①
Prepare the lamp, accessories and tools.
Unscrew the screws and remove the U-shaped bracket (Fig. 2)
②
Loosen the bottom screws to match the pole.
③
Install the luminaire (applicable to Φ50mm poles)
④
Adjust the luminaire and balance, then tighten the arc-shaped
support screws.
IMPORTANT
_____________________________________________________________________________
1. This is a solar powered lamp, please install it in a place where it
can receive plenty of sunlight.
2. Lighting time depends on the duration of sunlight and working
mode.
3. During the day, even when turned off, the luminaire can charge
the solar batteries.
4. Do not throw the battery into household waste to avoid explosion.
5. The luminaire is equipped with an internal battery that can be
replaced.
6. A qualified person can remove the light source and independent
control device without causing permanent damage to the luminaire.
[ EN ]
1
2
3
4
3
Publicidad
