KRESS KUB61 Manual Original página 11

Mode Selection
This tool comes with the adjustment functions by using four gear speeds and four auxiliary modes, which is
convenient for the operator to better operate the machine for work.
You can switch between 1st/2nd/3rd/4th speed gears by quick and short press; you can switch between four
auxiliary modes of wood/thin iron/thick iron/auto-stop by long press (for 1-3s).
Note: The switching of gear position/mode cannot be performed while the tool is running.
Application Mode (the auxiliary
type is displayed on the panel)
Wood mode
Thin iron mode
Thick iron mode
Auto-stop mode
Note: The automatic speed control function only works when the switch trigger is fully pushed.
Note: The reverse auto stop function only works when the tool rotates counterclockwise for driving.
Note: Push the switch trigger and then press the button when all indicators are OFF on the panel.
Note: All lights are OFF on the switch panel when the tool is turned off to save battery power. The types of ap-
plication mode can be checked by continuously pushing the switch trigger until the tool stops.
Max.
Impact
Rate
This mode helps to avoid the screw
from falling out when you start drill-
ing. The tool first turns the screw at
4200bpm
a low speed. Then it efficiently turn
the screw in at a full speed after the
screw is drilled to a certain depth.
This mode helps to avoid over-
The tool
tightening the screws. It also
stops as
increases the speed and improves
soon as
the quality. The tool drives screw to
the impact
rotate at high speed and stops as
starts.
soon as the impact starts.
This mode helps to avoid screw
damage or scratches. It also
increases the speed and improves
the quality. The tool drives screw to
rotate at high speed and reduces
3400bpm
the speed as soon as the impact
starts.
Note: Release the switch trigger im-
mediately after tightening to avoid
over-tightening.
This mode helps to avoid the screw
from falling out. When the bolt is
4200bpm loosened by reverse rotation, the
tool will automatically stop when
the bolt/nut is loose enough.
Function Application
Tighten the long
screws.
Securely tighten
the self-drilling
screw into the
thin metal plate
with good finish
Securely tighten
the self-drilling
screw into the
thick metal plate
with good finish.
Loosen the bolt.
11
EN