BGS technic 7681 Manual De Instrucciones página 3

COMPONENTS
1 Hydraulic spindle 10 t with sliding handle, external thread 1-1/2", length 250 mm
2 Strike spindle with movable strike pin, external hexagon 30 mm, length 285 mm
3 Pull arms
4 Pull arm disc, Ø 101 mm
5 Centering tip with extension for hydraulic spindle
6 Strike wrench for strike spindle, outer hexagon 30 mm, width 200 mm
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set is used to press out drive shafts or remove wheel hubs on passenger cars, vans and
smaller commercial vehicles with a bolt circle diameter of 125 - 215 mm. The tool set is particularly
suitable for stuck or rusted drive shafts and is suitable for wheel hubs with 3, 4, 5 and 6 wheel screws
and bolts.
SAFETY INFORMATIONS
•
Keep children and unauthorized persons away from the work area.
•
Keep this tool out of the reach of children
•
Only use the tool for work for which it is intended.
•
Check the condition of the tool regularly and replace damaged parts.
•
When lifting the vehicle, always use the lifting points provided by the vehicle manufacturer.
•
Before working under a vehicle, always ensure that the vehicle is adequately supported by jack
stands or ramps. Chock the wheels and make sure the handbrake is firmly on.
•
Make sure you have a secure, non-slip footing when working.
•
Make sure the tool is mounted properly.
•
Do not over-tighten the spindle or use excessive force as this may damage both the tool and the
component.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Hydraulic Drive Shaft Puller Set
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 7681
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed