Publicidad
Idiomas disponibles
Idiomas disponibles
My remote control does not work.
What should I do?
iHow
Come the Initial SetuP appears every
time I turn on this unit?
Why I cannot watch some TV programs.
How Come there is no image fron
i conne(
,_dexternal
devices?
I
. Check the antenna
or cable connection
to the main unit.
, Check the batteries of the remote control.
, Check if there is an obstacle between
the infrared sensor window
and the
remote control.
, Test the signal output.
If OK, then possible infrared
sensor trouble.
(Refer to"lR Signal Check" on page 36.)
, Aim the remote control
directly at the infrared
sensor window
on the
front of the unit.
, Reduce the distance
to the unit.
, Re-insert the batteries
with their polarities
(+/- signs) as indicated.
. When there is an infrared-equipped
device such as PC near this unit, it
may interrupt
the remote control
signal of this unit.
. Move the infrared-equipped
device away from this unit, change the angle
of the infrared
sensor or turn off the infrared communication
function.
, Connect
theRF coaxial cable to the Unit directly
and run the initial setup:
; Make sure to complete
the channel
scan before turning
offthe
unit.
, Make sure autoscan
has been completed.
(Refer to "Autoscan"
on page 18.)
, Autoscan
must be completed
when you set up the unit for the first
time or move it to a location
where previously
unavailable
channels are
broadcast.
, The selected
channel
may not be broadcasting.
, When autoscan
is interrupted
and not completed,
some channels will not be received. Make sure to complete.
(Refer to "Autoscan"
on page 18.)
, The selected
channel cannot
be viewed by the"Child
Lock"setting.
(Refer to "Child Lock" on page 26.)
, The unit requires some kind of antenna
input. An indoor
antenna
(VHF/UHF),
an external
antenna
(VHF/UHF)
or an RF coaxial cable from
your wall cable/satellite
box needs to be plugged
into the unit.
; Check if the right input mode is selected by pressing
[INPUT SELECT] or
using [CH A/Y],
(Refer to"Switching
Each Input
Mode"on
pag
• Checkthe
antenna
or cable connection
tO the unit,
When using the Composite
Video Connection
check that the Green (Y),
Blue (Pb/Cb) and Red (Pr/Cr)connectors
are connected
to their
corresponding
colored jacks on the unit.
. Many digital
channels have alternate
channel
numbers. The unit changes
Whenever
I entered channel
number,
the numbers
automatically
to the ones signifying
the broadcasting
it changes automatically,
stations. These are the numbers
used for analog
broadcasts.
i Captions
that are delaYed a few SeCondS behind
the actual dialogue
are
Why are captions
not displayed
entirely?
common
for live broadcasts.
Most Captioning
production
companies
can
Or, captions are delayed
behind
the
......
display
a dialogue
to maximum
of 220 words per minute.
If a dialogue
dialogue,
exceeds that rate, selective editing
is used to insure that the captions
remain
up,to date with the current TV screen dialogue.
How can I set the clock?
, There is no clock function
on this unit.
EN
Publicidad
