Hella Jumbo 320 FF Instrucciones De Montaje página 8

8
B min.
A min.
(mm)
(mm)
D
350 1.500
Tools required
• Ruler
Page 3:
Mounting steps
For upright/pendant mounting,
above/below bumper. Lamps should
neither vibrate nor extend higher
than the bonnet and must be fitted
symmetrically.
When mounting auxiliary lamps
with integrated position light it is
necessary to observe certain
mounting dimensions. If these
statutory mounting regulations are
not observed, or if the use of an
additional pair of position lamps is
not permissible do not operate the
C min. D min. position lights.
(mm) (mm)
Leave the lamp socket in the
auxiliary lamp to prevent leakage.
400 600
• Combination pliers
• Pliers for crimp connectors
(if available)
• 17 mm open end or box wrench
Determine mounting position on flat
surface and mark mounting points.
Drill pilot hole with 3 mm dia. bit and
then bore out to 11 mm.
Protect drilled metal parts with rust
protection paint.
Preliminarily install mount.
Open housing and install bulb 1 .
For position light version:
install bulb 2 .
Do not touch bulbs with bare fingers!
Use tissue paper or similar.
Statutory operating approval in
various countries for position light:
D F
A S
NL
CH
GB
permissible according to law
not permissible according to law
• Drill with 3, 5, 6, 11 and 12 mm
dia. bits
• 3 and 6 mm Allen keys
Assemble housing.
Screw holder and housing together
and route cable cleanly.
Screw lamps to vehicle (use two-
point mount if required).
Align lamps and tighten screws.
E
I
FIN