Nevadent PROFESSIONAL CARE NMD 3.7 D8 Instrucciones De Uso página 12

Charging the appliance
Note
► Before starting to use the appliance, check that it is in fault-free condition. You must
not use the appliance if it has any faults.
► Charge the appliance only when there is no water in the water tank
► In the following cases, the appliance must be charged for about 15 hours:
–
Before first use.
–
If the battery has been drained during use.
–
If you have not used the appliance for more than 3 months.
► A fully charged battery is enough for about 20 minutes of use.
1) Plug the mains plug into the mains power socket.
2) Place the handpiece
on the charging station
3) Allow the handpiece
first time. The charge indicator
red during the charging process. When the battery is fully charged, the charge
w
indicator
4) Place the handpiece
power is always available.
Filling the water tank
ATTENTION!
► Fill the water tank
wash. The water tank
mouthwash or mouth rinse.
► Use only cold or lukewarm water with a maximum temperature of 40°C. Do not fill
the water tank
You can fill/top up the water tank
1) Take the handpiece
q
station . Hold the switched-off handpiece
2) Open the water tank lid
3) Close the water tank lid
NMD 3.7 D8
5
on the charging station
q
.
5
to charge for around 15 hours before using it for the
w
lights up green.
5
on the charging station
6
with pure tap water. If necessary, add a few drops of mouth-
6
should never be completely filled with additives such as
6
with hot water.
6
at any time without removing it from the appliance:
5
with the attached empty water tank
7
and fill the tank with water through the filling opening
7
.
q
so that it slides onto the pin
on the front of the handpiece
q
after each use so that full
6
5
horizontally.
6
.
5
lights up
from the charging
7
.
GB │ IE │ 9 ■