Storing Your Dishwasher - Sears Kenmore Ultra Wash 15951 Manual De Uso

Storing your dishwasher
Moving or winterizing your dishwasher
Protect your dishwasher and home against water damage
due to freezing water lines. If your dishwasher is left in a
seasonal dwelling or could be exposed to near freezing
temperatures, have a qualified person do the following:
1. Disconnect power.
2. Turn off water supply to the dishwasher.
3. Remove the 4 screws on the lower access panel and
remove the lower access panel I_1.
4. Place a shallow pan under the water supply valve.
Then, use a wrench to disconnect the water inlet
from the water supply valve. Separate the water
inlet from the water supply valve and drain water
into the pan 171.
5. Remove the spring clamp from the water outlet and
separate from the water supply valve; drain water
into pan.
6. Reconnect both water inlet and water outlet to the
water supply valve.
7. Empty the pan and reposition it under the water pump.
8. Remove the clamp and disconnect the drain hose from
the water pump; drain water into pan.
9. Reconnect drain hose to the water pump, being sure to
position the clamp over the connection.
10. Replace the lower access panel.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower access panel and
remove lower access panel.
2. Turn on the water supply to dishwasher.
3. Reconnect power.
4. Run dishwasher through a complete cycle and check
for leaks.
5. Replace lower access panel.
NOTE: If your dishwasher is connected to a garbage
disposal, do not run water into the sink after winterizing.
This could cause water to refill the drain hose on your
dishwasher.
Storing for the summer
Protect your dishwasher during the summer months by
turning off the water supply and power supply to the
dishwasher.
J
18