Descargar Imprimir esta página

EGO PRO X BCX4500 Traducción De Las Instrucciones Originales página 15

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 39
TROUBLESHOOTING
PROBLEM
Fail to start
The machine stops
working while cutting
The cutting line can't
be released (only using
with trimmer head).
Grass wraps around
trimmer head and
motor housing
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER/BRUSH CUTTER — BCX4500
CAUSE SOLUTION
The battery pack is not attached to the
line trimmer.
No electrical contact between the
machine and battery.
The battery pack is depleted.
The lock-off lever and trigger switch are
not depressed simulta-neously.
Heavy cutting line is used.
The motor is overloaded.
The battery pack or machine is too hot.
The battery pack is disconnected from
the machine.
The battery pack is depleted.
The motor shaft or trimmer head is
wound with grass.
There is no enough line in the trimmer
head.
The trimmer head is dirty.
Line is tangled in the trimmer head.
The line is too short.
Cutting tall grass at ground level.
SOLUTION
Attach the battery pack to the line
trimmer.
Reinsert the battery pack.
Charge the battery pack.
Press down the lock-off lever and hold
it, then depress the trigger to turn on
the machine.
Use recommended nylon cut-ting line
with diameter no greater than 2.7 mm.
The machine will recover when the load
is removed. For con-tinuous working,
reduce the load of the machine.
Allow the battery pack or machine to
cool until the tem-perature drops below
67°C.
Re-install the battery to the machine.
Charge the battery pack.
Stop the trimmer, remove the battery
and remove the grass from the motor
shaft and trimmer head.
Remove the battery and re-place the
cutting line; follow the section "LINE
REPLACE-MENT" in this manual.
Remove the battery and clean the lower
cover assembly, spool and upper cover.
Remove the battery, remove the line
from the spool and re-wind; follow the
section "LINE REPLACEMENT" in this
manual.
Remove the battery and pull the line
while alternately pressing down on and
releasing the trimmer head.
Cut out the weeds into several sections
from top to ground level.
EN
15

Publicidad

loading