Publicidad
Idiomas disponibles
Idiomas disponibles
To allow the water level in the pool to be raised to 50 mm from the top of the pool wall.
Skims the surface of the water.
Captures large debris (leaves, toys, large insects, etc.)
Overflow, to be punched out
Leaktight installation with a liner (75/100, 85/100, 150/100)
tooLS anD nuMBeR of peopLe RequiReD foR inStaLLation
Same as a standard skimmer. According to the DTP n°8 "pool fitting" (January 1998)
Use only the fibrous concrete and welded mesh provided to seal in the copings beside the mirror skimmer
You will need 2 pieces of Hung liner locking track to be placed under the ends of the SS reinforcement.
Pool coping
-
Min length 500 mm
-
Min depth 30 mm
-
The mirror skimmer must be installed with an automatic water level regulator and an overflow system.
-
The " Hung " liner locking track must be placed on 2 silicon beads.
-
Linerlock must be used to ensure a leaktight seal.
As for pool fittings.
1) Sealing in the skimmer
a. Position the mouth flush with the wall
b. The SS reinforcement is placed on 2 pieces of Hung (just behind the hook section).
c. Clean the entire underside of the skimmer mouth using a rag soaked in a PVC compatible solvant, then sand
it using a rough grain emery paper to improve the adhesion of the fibrous concrete to the ABS surface.
puRpoSe of tHe pRoDuct
ReStRictionS
SafetY aDVice anD RecoMMenDationS
upKeep anD Maintenance
aSSeMBLY inStRuctionS
12/32
2014/03 - Indice de révision : A - Code : 0025110
Publicidad
