Publicidad
Idiomas disponibles
Idiomas disponibles
▪
Saw blades must be kept sharp and in good condition. Replace partially fractured and
broken saw blades immediately.
▪
Work calmly and evenly with the jig saw. You will thus avoid accidents and the saw blades
and the jig saw will last longer.
7
OPERATING INSTRUCTIONS
7.1
Changing the saw blade (Fig 1)
Releasing the saw blade.
Turn the screws anticlockwise (A)
Insert the saw blade in the ram up to the stop and tighten the two screws of the retention clip.
Important ! : Make sure the saw blade sits properly in the slot of the roller and ram.
7.2
Switching ON/OFF (Fig 2)
Switching ON : Press the On/Off switch.
Continuous operation. Lock the On/Off switch with the locking button.
Switching Off : Press the On/Off switch and release.
A: locking button
B: ON/Off switch
7.3
Adjusting the base (fig 3)
Loosen the 2 screws to set the base to an angle up to 45° on the right or left side and re-tighten
the screws.
7.4
Dust extraction
The jigsaw is equipped with a dust extractor socket. You can connect your vacuum cleaner to
the socket at the rear of the jigsaw. If you require a special adapter, please contact the
manufacturer of your vacuum cleaner.
8
TECHNICAL DATA
Nominal voltage
Power consumption
Cutting rate
Cutting depth in wood
Cutting depth in steel
Cutting depth in plastic
Mitre cuts
Connection type
9 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is over 85 dB(A).
aw (Vibration)
Copyright © 2024 VARO
POWC20100
230-240 V - 50 Hz
350W
3000 min
45 mm
6 mm
10 mm
Up to 45° (left and right)
Universal
86 dB(A)
97 dB(A)
17.9m/s²
P a g e
| 5
-1
K = 1.5 m/s²
www.varo.com
EN
Publicidad
