Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE & ADJUSTMENT GUIDE
CLEANING
The stepper can be cleaned with a soft, clean, and damp cloth. Do not use abrasives or solvents on
plastic parts. Please wipe your perspiration off the stepper after each use. Be careful not get
excessive moisture on the computer display panel as this might cause electrical hazards or
electronics failure.
Please keep the stepper, especially the computer, out of direct sunlight to prevent screen damage.
Please inspect all assembly bolts and pedals on the stepper for proper tightness every week.
STORAGE
Store the stepper in a clean and dry environment, away from children.
NOTES:
If you are having a hard time balancing on the stepper, please hold onto something for support.
Do not use the stepper for more than 15 minutes as the hydraulic cylinders may overheat and
become damaged.
P L A S T I C C A P
B A T T E R Y
B A T T E R Y S E A T
1. Remove Computer (No. 22) from Main Frame (No. 1) and disconnect the link wire of
Sensor (No. 10) from the Computer (No. 22).
2. Remove the plastic cap from the battery seat.
3. Remove the battery using your fingers.
4. Insert the new battery using your fingers. Ensure that the positive side of the battery which is
labeled with a + sign is facing upward once the new battery is in place.
5. Place the plastic cap over the battery seat.
6. Insert the link wire of Sensor (No. 10) onto the wire inserting hole on the back of Computer
(No. 22).
7. Insert the Computer (No. 22) onto Main Frame (No. 1).
ADJUSTING THE PEDAL STEPPING HEIGHT
Turn the Adjustment Knob (No. 29) clockwise to
increase the stepping height. Turn the Adjustment
1
Knob (No. 29) counter-clockwise to decrease the
29
stepping height.
CHANGING THE BATTERY
W I R E I N S E R T I N G H O L E
22
BATTERY
PLASTIC CAP
10
1
6
Publicidad
