Bradley 2923-28W001 Manual De Instrucciones página 3

Unpacking
Unpack all items from the shipping box. Packaged items should include hand dryer, owners manual,
mounting template and tamper-proof wrench. Review and report any missing or damaged items.
Installation
1. Disconnect the power source at the distribution panel.
2. Determine the recommended mounting height for gender/age (Table 2). Select a mounting
location where no reflective surfaces )countertop or wash basin( are closer than 18 in )46
cm) below the dryer. Avoid mounting where the dryer may be directly exposed to natural light
(sunlight). When mounting adjacent to an existing dryer, the dryers should be spaced at least 24
in (61 cm) apart.
3. Select the access for electrical connections through the rear or bottom of the dryer's mounting
plate matching the supply wiring access.
4. Using the mounting template provided, mark locations for the mounting bolt holes on the wall.
For stud walls, ensure at least one fastening location will be secured to a stud.
5. Use the tamper-proof wrench supplied to loosen the cover mounting screws (turn screws
clockwise) to remove the cover from the dryer.
6. Fasten the base to the wall, using the type of bolts recommended (Table 3).
7. Connect the dryer to the supply wiring.
8. Replace cover, tighten cover mounting screws (turn screws counter-clockwise) making certain
not to over-tighten.
9. Connect the power source at the distribution panel.
Table 2
Recommended Mounting Heights from Floor to Dryer Bottom Edge
Men's washrooms
Women's washrooms
Children's washrooms, ages 4-7
Children's washrooms, ages 7-10
Children's washrooms, ages 10-13
Children's washrooms, ages 13-17
Handicap Mounting Height
Table 3
Type of Wall
Hollow Tile, Lath, Wall
Board or Metal
Cement, Brick, or Tile
Covered Cement or Brick
Stud Wall
No 10 (M5) Screw Type or Wing Type Toggle Bolts
No 10 (M5) Flanged Plastic Anchors for Block or Brick
No 12 (5.5 mm) Wood Screws
3
46 (117)
44 (112)
40 (102)
44 (112)
Type of Bolt
in. (cm.)
32 (81)
36 (91)
37 (94)