Publicidad
Getting Started/Instruction for Use
Step 1.
Wash your hands, then remove filter
from filter box.
Step 2.
Please soak it in cold tap water for 10
minutes to remove bubbles before use
to activate the filter and ensure the
best filtration performance.
[Figure 1.1]
Figure 1.1
Step 3.
Hand-wash pitcher, lid and reservoir
with a mild detergent. Don't put it in
the dishwasher or use abrasive cleaners.
Rinse thoroughly with water after
washing.
Step 4.
Install filter into reservoir. Press
firmly to ensure a tight seal.
[Figure 1.2]
Figure 1.2
Step 5.
Fill the reservoir with cold tap water.
Discard the first two pitchers of filtered
water.
Step 6.
Hold the button for 5 seconds until
the blue light flashes to activate the
indicator. [Figure 1.3]
Note: Repeat this step after each new
filter replacement.
Button
Figure 1.3
Remaining
Indication
Status
light
life(day)
Good
Blue
stay on for
＞10
5 seconds
Blue
Replace
soon
Red
≤10
flash 6 times
Red
Replace
Red
now
≤0
stay on for
10 seconds
Red
When you have filtered 200 gallons of
water or the filter life indicator red light
is on, whichever comes first, you should
change your filter.
Publicidad
