Publicidad
Idiomas disponibles
Idiomas disponibles
1. Turning Fan On: Place fan on stable level surface. Plug fan into properly grounded outlet. To start the fan, turn the
switch from the OFF position to the desired fan speed. 1-LOW, 2-MEDIUM, 3-HIGH. Turn dial to 0-OFF to discontinue
use. Unplug fan when not in use.
Oscillation: To start the fan with oscillation, turn the control dial counterclockwise to the desired speed level with the
arrow above. -LOW, -MEDIUM, -HIGH. Turn dial to 0-Off to discontinue use. Unplug fan when not in use.
Note: Some models come with a plug where you can replace a fuse. If your model has this, please read, and follow the
below instructions to replace the fuse.
This product employs overload protection (fuse). A blown fuse indicates an overload or short‑circuit situation. If the fuse
blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product
marking for proper fuse rating) and check the product. If the replacement fuse blows, a short‑circuit may be present,
and the product should be discarded or returned to an authorized service facility for examination and/or repair.
Fuse Replacement:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Open fuse cover by sliding open fuse access cover on top of attachment plug towards blades. See Fig. 2
3. Remove fuse carefully. Use a small tool to pry the end of the fuse from holder cavity. Be careful not to break the
glass window.
4. Replace fuse.
WARNING: Risk of fire. Replace fuse only with identical 2.5 or 5.0 Amp, 125 Volt fuse (3.6mm x 10mm). Be sure the fuse
is properly seated within its cavity. Close fuse cover by sliding it back to its original closed position.
Fig. 1
Fig. 2
~ 4
Fig.3
Publicidad
