Descargar Imprimir esta página

Tripp-Lite OmniSmart OMNI750ISO Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed
during the installation, operation and storage of all Tripp Lite UPS
Systems. Failure to heed these warnings will void your warranty.
UPS Location Warnings
• Install your UPS indoors, away from excess moisture or heat, dust or
direct sunlight.
• For best performance, keep the indoor temperature between between
32º F and 104º F (0º C and 40º C).
• Leave adequate space around all sides of the UPS for proper ventilation.
UPS Connection Warnings
• Connect your UPS directly to a properly grounded AC power outlet. Do not plug
the UPS into itself; this will damage the UPS.
• Do not modify the UPS's plug, and do not use an adapter that would eliminate
the UPS's ground connection.
• Do not use extension cords to connect the UPS to an AC outlet. Your warranty
will be voided if anything other than Tripp Lite surge suppressors are used to
connect your UPS to an outlet.
• If the UPS receives power from a motor-powered AC generator, the generator
must provide clean, filtered, computer-grade output.
Equipment Connection Warnings
• Do not use Tripp Lite UPS Systems for life-support appliances in which a
malfunction or failure of a Tripp Lite UPS System could cause failure or
significantly alter the performance of a life-support device.
• Do not connect surge suppressors or extension cords to the output of your
UPS. This may damage the UPS and will void the surge suppressor and UPS
warranties..
Battery Warnings
• Your UPS does not require routine maintenance. Do not open your UPS for any
reason. There are no user-serviceable parts inside.
• Batteries can present a risk of electrical shock and burn from high short-circuit
current. Observe proper precautions. Do not dispose of the batteries in a fire.
Do not open the UPS or batteries. Do not short or bridge the battery terminals
with any object. Unplug and turn off the UPS before performing battery
replacement. Use tools with insulated handles. There are no user-serviceable
parts inside the UPS. Battery replacement should be performed only by
authorized service personnel using the same number and type of batteries
(Sealed Lead-Acid). The batteries are recyclable. Refer to your local codes
for disposal requirements or in the USA only call 1-800-SAV-LEAD or
21-10-081 932490-Book.indb 2
21-10-081 932490-Book.indb 2
2
10/26/2021 1:08:08 PM
10/26/2021 1:08:08 PM

Publicidad

loading

Este manual también es adecuado para:

Omnismart omni500isoOmnismart omni1000iso