Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting the attachment pipe
Mount the attachment pipe to the power unit.
1.
Turn the lever toward the cutting attachment.
► 1 . Lever
2.
Align the pin with the arrow mark and insert the
attachment pipe until the release button pops up.
► 1 . Release button 2. Arrow mark 3. Pin
3.
Turn the lever toward the power unit.
► 1 . Lever
Make sure that the surface of the lever is parallel to the
pipe.
To remove the pipe, turn the lever toward the cutting
attachment and pull the pipe out while pressing down
the release button.
1
1
2
3
1
Fig.12
► 1 . Release button 2. Lever 3. Pipe
Adjusting the handle/hanger
position
Adjust the handle and hanger position to obtain confort-
able handling of the tool.
Loosen the hex socket head bolt on the handle. Move
the handle to a comfortable working position and then
tighten the bolt.
► 1 . Handle 2. Hex socket head bolt
Loosen the hex socket head bolt on the hanger. Move
the hanger to a comfortable working position and then
tighten the bolt.
► 1 . Hex socket head bolt 2. Hanger
9 ENGLISH
1
2
1
2
2
1
3
Publicidad
