Fermax MINI 1PTA WG Manual De Usuario página 16

Cod. 97864 V09_17
Example: - PIN 9876 ID=1:
-PIN 6543 ID=5:
Change PIN
Programming Step
Note: Below is done outside programming mode, users can undertake this themselves
1. Change the card associated PIN
(There will auto associate PIN (8888)
to cards when adding card users)
1. Change the users' PIN
Example: - Code 9876 ID=1:
-Code 6543 ID=5:
Delete User Card(s) or PIN(s) by Remote Control
Programming Step
1. Enter Program Mode
2. Delete User By User ID
OR
2. Delete User – By Card
OR
2. Delete User – By Card number
OR
2. Delete User – By PIN
OR
2. Delete All User
3. Exit Program Mode
Controller programming
BY REMOTE CONTROL
Note:

Remote Control: Please use the Infrared Remote Control to program the controller. The
"IR" on the controller is the infrared receiving window, please direct the Remote Control to
it.
Set Relay Configuration
The relay configuration sets the behavior of the output relay on activation.
Programming Step
1. Enter Program Mode
2. Pulse Mode
OR
2. Toggle Mode
3. Exit Program Mode
* (Master Code) # 1 1 #9876#*
* (Master Code) # 1 5 #6543#*
*1 #9876#New PIN#New PIN#*
*5 #6543# New PIN # New PIN #*
Keystroke Combination
* (Master Code) #
3 (1~99) #
The relay time is 2~99 seconds. (1 is 50mS)
(Factory default is 5 seconds)
3 0 #
Sets the relay to ON/OFF Toggle mode
*
6
Keystroke Combination
* (Read Card) (Old PIN) # (New PIN) #
(Repeat New PIN) # *
(PIN: 4~6 digits)
* (ID Number) # (Old PIN) # (New PIN) #
(Repeat New PIN) # *
(PIN: 4~6 digits)
Keystroke Combination
* (Master Code) #
2 (User ID) #
2 (Read Card on External Reader) #
2 (Input last 8 digits Card number) #
2 (Input PIN) #
2 (Mater Code) #
*