Instructions For Installation; Electrical Installation; Use And Maintenance - S&P BOX-600 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTRUCTIONS FOR INSTALLATION

Securing to the wall
hotplates or 750 mm in the case of gas burners or mixed installations. (Fig.1)
(This distance may vary according to national regulations).
user. (Fig. 2)
a remote unit.
the hood is to be fitted. Insert plugs and screws without tightening completely, in such a manner that the
hood can be supported from them.
to model purchased). Remove the hood and drill the two holes where marked, use a ø6 drill, then insert
the plugs. Hang the hood again and tighten the two screws to secure.
• Fit the evacuation tube. If the evacuation tube is short and two or more tubes must be joined, make sure
that the diameter is not narrowed at the joints and avoid air leaks at the connection point.
To facilitate the connection of the hood to the remote fan unit, we have the necessary accessories.
Consult our catalogue to see the accessories.
www.solerpalau.com

Electrical Installation

• Make sure the mains voltage and frequency coincide with those on the characteristics plate on the hood
and the remote extraction unit.
• This device has been designed with Class II electrical shock protection, therefore do not connect any
cable to the earth connection.
• Connect the cable from the motor to the terminal block located inside the electrical connection box labelled
MOTOR. Make sure the connections are correct.
Securing the decorative telescopic chimney
• Secure the chimney support 20 mm from the ceiling and aligned with the centre of the hood A (Fig. 6). Once
it has been secured with the screws B, secure the upper part of the telescopic chimney to this support,
taking into account that the upper part goes inside the lower part.
• Once the upper part has been secured, slide the lower part and join it to the hood using the screws A
indicated in figure 7.

USE AND MAINTENANCE

• TThe hood has a multi-position switch to select the extraction speed of the air. It also has a switch for the
Blue = N (Neutral).
Brown = L (Live)
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Box-900 ixHs-600900bHs-900 ixCf 60bCf 60 ix

Tabla de contenido