Grohe SENSIA 36507SH0 Manual De Instalación página 14

Supplied items
E-bidet (seat unit)
Water supply hose and clip
T-joint
Remote control and holder
Screws, anchors (for remote control)
Power socket
Ceramic
Protection sheet, mounting bases and washers (for
ceramic)
Spray hood
* If needed to connect with the socket outside the
wall.
Strainer (display model [14533SH0] only)
Black tube (item no. 49 205)
* Required for the installation with GROHE concealed
cistern.
Installation kit for automatic flush (item no. 46 944)
* Start with the installation of the automatic flush kit.
Adaptor valve for 4.5 L cistern (item no. 42 333)
Necessary tools
Spanner (19 mm)
Monkey wrench
Crosshead screwdriver
Flat-blade screwdriver
Flat-blade precision screwdriver (2.5 mm)
Crosshead precision screwdriver (No. 0)
Ratchet (19 mm)
Grinder
Pipe cutter
Level
File
Tape
Ruler
Pen
Adhesive
Utility knife
Preparation
Turn off the power breaker.
For the GROHE concealed cistern
Remove the pipe cover.
For other concealed cisterns
Cut out the wall.
Adjust the length of the bolts protruding from the wall.
Pull the power cord out from the wall.
Thread the power cord into the power socket parts,
and connect the wires.
Note
• Make sure you attach the wires into the
corresponding inlets.
Fasten the parts of the power sockets together.
Note
• Tighten the pieces securely.
Remove the inspection chamber cover.
Preparing the water supply
hose
Detach the two components from the water supply
hose.
Route the water supply hose through the channel up
to the water shutoff valve.
Attaching the T-joint
Close the water shutoff valve, and detach the water
supply hose.
Attach the T-joint to the water supply hose on the
filling valve side, and attach the other end of the
corporation cock to the water shutoff valve. Tighten it
with wrench.
Remove the cap, and reattach the two components of
the water supply hose, then attach the water supply
hose to the bottom of the T-joint.
Place a bucket beneath the water supply hose.
Open the water shutoff valve, and rinse out any dirt in
the water supply hose.
Check for water leaks around the water shutoff valve
areas.
Note
• If there is a leak, tighten the leaking area securely.
Close the water shutoff valve.
10
GB