ACD GRUPPE MFT10 Guía Breve página 5

2 Description Accessories
2.1 Power Pack (Table Power Supply)
The power pack supplies the MFT10/MFT12 with power when used with mains supply.
Figure 8: Power pack
2.1.1 Security Advices
Only original ACD power packs may be used for operating the
MFT10/MFT12. Do not use the ACD-approved components with a
third-party device. Observe the input voltage range on the rating
plate.
ATTENTION
Prior to each use, the vehicle terminal incl. battery as well as the
connection cables must be inspected for damage. Damaged parts
must be replaced. Please contact ACD in this case.
ATTENTION
Make sure there is no risk of stumbling over connection cables or
power packs.
ATTENTION
In order to prevent excessive heat, the vehicle terminal incl.
battery, as well as the power pack (if a power pack is used), must
not be covered while in use.
ATTENTION
2.1.2 Mounting (when connected with mains)
Insert the table power supply into the cable entrance area of the back of the device (Figure 9). For access to
the connection ports, remove the cable shaft cover with screw connection. Then connect the cold device
cable to the mains. The input voltage of the mains must be between 100 V and 240 V and have a frequency
of between 50 Hz and 60 Hz.
Figure 9: Connection Ports, back of the device
MFT10_MFT12_Accessories_Accesorios_Brief_Overview_Resumen_breve_FCC_V1.10_en_es 5 / 28