Basic Set-Up And Connections; Initial Setup; Quicktips - Sanyo DS32224 Manual Del Propietário

Basic Set-up and Connections

QuickTips

The TV will automati-
I
cally select the correct
Antenna mode for the
type of RF signal you
connect.
TV will switch off
I
automatically after 15
minutes if there is no
signal reception (cable
out or station not
broadcasting).
Exception—When the
Video mode is selected,
the TV will not automat-
ically switch off when
signal reception has
stopped for 15 minutes.
If you move the TV to a
I
new location, press the
RESET key twice after
connecting the signal
and turning on the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which
is capable of receiving cable
channels, the consumer
must subscribe to the cable
company's service.
4
Basic Set-up and Connections
INITIAL SET-UP
1. Install batteries in remote control, see page 8.
2. Connect signal, see below.
3. Plug in AC power cord.
4. Press POWER key to turn on TV.
5. Follow on-screen instructions, see pages 13~14.
CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
‚
Note: If you do not have
a cable box connect cable
directly to TV 75 ohm
jack or VCR.
Note: If you do not have a VCR
connect signal directly to TV 75
ohm jack.
Operational Tip for No Signal Connection:
If the TV is used as a monitor only, with a DVD player or some other type of external
equipment, and no cable or antenna signal is available, the following condition will occur:
– Your TV is designed to automatically search for available channels. Therefore, the
initial start up requires that you press the MENU key, enabling the TV to automatically
go through the channel search process before you can operate the TV. After the initial
channel search is completed, you must press the MENU key again to complete the
channel search process. This may take several minutes.
After the channel search process is complete (2 searches), you can press the INPUT
–
key on the remote control to use the TV as a monitor.
‚
Satellite Receiver
Cable Box
CATV IN
CH3
CH4
OUT TO TV
IN OUT
VIDEO L- AUDIO -R IN FROM
S-VIDEO
SAT.
VIDEO L- AUDIO -R
VCR Back
IN
FROM ANT.
OUT
OUT TO TV
VIDEO AUDIO INPUT
COMPONENT AV2 AV1
S-VIDEO
UHF/VHF/CATV
VIDEO
Y
AUDIO
OUTPUT
P
(MONO)
b
L L L
P
R AUDIO R
r
R
‚
RF Antenna
TV Back
75Ω