Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Run the compressor
for 15
minutes. Make sure the drain
valve is open and there is minimal
air pressure build-up in tank.
6.
After 15 minutes, close the drain
valve by turning clockwise. The
air receiver will fill to "cut-out"
pressure and the motor will stop.
The compressor is now ready for use.
Before
Each Start=Up:
1,
Place On/Auto/Off
lever to "Off".
2.
Pull the regulator knob out and
turn counterclockwise
to set the
outlet pressure to zero.
3.
Attach hose and accessories.
NOTE: The hose or accessory
will require a quick connect plug
if the air outlet is equipped with a
quick connect socket.
Risk of Bursting,
Too much air
pressure
causes a hazardous
risk of bursting,
Check the
manufacturer's
maximum
pressure
rating for air tools and accessories.
The regumator outNet pressure
must never exceed the maximum
pressure
rating,
Bow
to Start:
1.
Turn the On/Auto/Off
lever
to "On/Auto" and allow tank
pressure to build.
Motor will
stop when tank pressure reaches
"cut-out"
pressure.
2.
Pull the regulator knob out
and turn clockwise to increase
pressure. When the desired
pressure is reached push knob in
to lock in place.
The compressor
is ready for use.
A10819
14-ENG
Publicidad
