Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4.
Use the hose clamp to secure the flexible tube
around the elbow tube.
5.
Place the control cable over the wire mounting
clip and ensure it is securely locked in place by
the curved wire tabs.
3.3
INSTALL THE REAR BLOWER TUBE
1.
Align the grooves on the rear blower tube with the
tabs on the tube connector.
2.
Slide the rear blower tube onto the
tube connector aligning the tabs with the
corresponding grooves.
3.
Rotate the rear blower tube clockwise until the
tabs lock into place.
PUT THE CORD IN THE CORD RETAINER.
3.4
INSTALL THE FRONT BLOWER TUBE
1.
Align the grooves on the front blower tube with
the tabs on the rear blower tube.
WARNING
English
2.
Slide the front blower tube onto the rear blower
tube aligning the tabs with the corresponding
grooves.
3.
Rotate the front blower tube clockwise until the
tabs firmly lock into place.
Note: The front tube has two adjustable positions. To
adjust the length, utilize the secondary grooves of the
front blower tube and secure them with the tabs on the
rear blower tube.
4
OPERATION
This section describes how to operate the product.
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
4.1
BEFORE YOU USE THE PRODUCT
4.1.1
CONNECT THE BATTERY CHARGER
1.
Connect the battery charger to the proper voltage
and frequency that is specified on the rating plate.
2.
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
4.1.2
CHARGE THE BATTERY
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
4.1.3
BATTERY INFORMATION
Refer to the Battery Operator Manual for information
about how to use the battery.
4.1.4
CONNECT THE BATTERY TO THE
PRODUCT
ONLY USE GREENWORKS ORIGINAL
BATTERIES WITH THE PRODUCT.
1.
Make sure that the battery is fully charged.
8
WARNING
WARNING
Publicidad
