Publicidad
Idiomas disponibles
Idiomas disponibles
CORRECT MANUAL FILTER CLEANING PROCESS
1) To remove the filters, disconnect the iQ Lite from the power, remove the micro-perforated
metal filter by turning it counterclockwise and gently pull back to remove it completely. After
removing the metal filter, remove the fabric filter (PMF TECH) by sliding it backward. (Fig. 3).
2) Use the cleaning accessories included in the Care Kit to remove dust and particle buildup on
the filters in order to remove heavily encrusted dirt. Wash the filters by soaking them in a
container with warm soapy water for 20 minutes. After that, scrub internally and externally to
remove dirt. Then rinse the filters under the water faucet: make sure the water flows through
without ponding. If water flows through the filters, the filters have been properly cleaned. If the
dirt persists, repeat the operation and reduce the time between manual washes; these times vary
depending on the dirt in the environment of use. (Fig. 4)
WARNING: MAKE SURE THE FILTERS ARE COMPLETELY DRY AND FREE OF MOISTURE
BEFORE BEING INSERTED INTO THE DRYER. CLEAN THEM FREQUENTLY.
3) Reposition the filters. Start with the fabric filter (PMF Tech) and then the micro-perforated
metal filter. After that, carefully rotate clockwise to ensure correct positioning of the
micro-perforated metal filter.
WARNING: Correct positioning on the interlocking guides and sliding without exerting any
pressure is extremely important. If the positioning of the filters is not correct, excessive pressure
could damage them and even cause them to break. (Fig. 3).
12
Publicidad
