Boston HPS 10HO Manual Del Propietário página 5

Connections
After your speakers are properly placed, you are ready to wire your system.
NOTE: Power is always supplied to the subwoofer electronics unless it is unplugged or switched to the off position using the
power switch located on the rear panel. The auto-on circuitry only activates or deactivates the power amplifi er. Make sure
your subwoofer and receiver are unplugged when making the connection.
Power: When plugging your subwoofer in be sure to use a wall outlet, or dedicated electrical outlet. Some receivers will
provide a switched outlet. Do not use this. These on board electrical outlets do not off er the amount of current or proper
isolation required by a power amplifi er, such as the one in your amplifi er.
Line level or LFE: On most systems use the line level input or the LFE input. These inputs accept the line-level signal from
your receiver's subwoofer output. Your receiver's manual should indicate which input is most appropriate.
Connecting the Subwoofer to Digital Home Theater Systems Using LFE
Digital 5.1, 6.1 and 7.1 home theater electronics dedicate one channel (the ".1") to reproduce the special low-frequency (LFE)
information (such as explosions and thunder) contained in digitally-encoded soundtracks.
Select "subwoofer-yes" from your receiver's set-up menu. Hooked up this way, the receiver's amplifi er is relieved of having to
reproduce the diffi cult low bass signals that can drive the receiver into audible distortion. In some cases it can also depend on
several other settings within a receiver. We recommend consulting your receiver manual for further assistance in this area.
Use an RCA cable (not included), as shown, to connect your digital receiver's LFE subwoofer output to the subwoofer.
Connect the other end to the LFE input.
digital receiver
Connecting the Subwoofer to Stereo or Dolby® Pro Logic®
For stereo or Dolby Pro Logic systems use the "sub out" connection from your receiver to the input on the subwoofer marked
"Left" and "Right".
receiver
use either input
5