Publicidad
Idiomas disponibles
Idiomas disponibles
Once the appliance has been loaded, start it by setting the [0/1] switch to "1": the
switch will light up red.
Leave the appliance to complete the drying process. The required time varies
depending on the moisture content of the garments, their thickness and the desired
level of residual moisture, which is normally inversely proportional to the ease of
subsequent ironing, if necessary.
It is helpful to check the dryness from time to time by feeling the garments until the
desired dryness is achieved.
At the end of drying, stop the appliance by setting the [0/1] switch to "0": the red light
on the switch turns off.
Remove the garments and wait for the appliance to fully cool before disassembling
and stowing it.
6.
CLEANING AND MAINTENANCE
The product does not require maintenance understood as the replacement of
consumables or scheduled servicing; it is normally sufficient to regularly clean the
surfaces, paying particular attention to any build-up of dust on the top of the rods,
since the dirt can be transferred to the clean garments. All cleaning must absolutely
be carried out with the power cord disconnected and, before reconnecting, ensure
that all parts are completely dry. Use a simple, strictly non-abrasive cloth (as damaged
aluminium can transfer colour to garments) and wipe gently: then dry approximately
with a dry cloth. In any case, strictly avoid aggressive detergents, abrasive sponges,
steel wool or other chemical cleaners. Since clean clothes are normally placed on the
appliance, it is unlikely that it will need to be cleaned.
7.
TROUBLESHOOTING
Problem
The switch light
doesn't turn on
Should any malfunctions occur other than those listed above, including the failed or
partial heating of the rods with the switch on, a self-sufficient solution is not feasible
and the appliance must be inspected by a qualified technician.
Possible cause
The power cord is
disconnected
The electrical outlet is not
powered
17
Probable solution
Connect the power cord
Check the switches on the electrical panel
Publicidad
