Publicidad
8. Line In
This is a stereo mini jack input. Connect the output of your audio device here and
adjust the player's volume to match that of your guitar to enable you to play along.
NOTE: This connection is stereo, and will remain stereo from the Emulated Output
Stereo Jack Socket (6). All others outputs will mix the incoming stereo signal and
output a mono version.
Ring
Tip
Screen
9. Effects Loop Level
The Effects Loop Level switch sets the effects loop to either +4dBV/-10dBV, which
enables you to use it with either professional equipment (+4dBV setting), or with
guitar level effects such as effects pedals (-10dBV setting).
10. Effects Loop Return
Connect the (mono) output of an external effects unit here.
11. Effects Loop Send
Connect the (mono) input of an external effects unit here.
12. Footswitch
The latching 2-way footswitch can be connected here. The footswitch will enable
the selection of the Clean and Overdrive channels, and the two voices on each
Channel.
NOTE: Using a footswitch will disable the front panel channel and voice switches.
Therefore, full control via the footswitch is granted irrespective of how the amplifier
is set.
EXTERNAL SWITCHING: This can also be used by people who wish to control
the main features of the amp using an external switching device that connects via
the TRS connection of the socket.
The following external conditions will switch the channels and voices as follows:
TIP
RING
Closed
Closed
Closed
Open
Open
Closed
Open
Open
12
Right channel
to mixer
Left channel
to mixer
CHANNEL
VOICE
Clean
Voice 1
Clean
Voice 2
Overdrive
Voice 1
Overdrive
Voice 2
13. USB
This USB-C socket is for connection to a computer via a suitable lead (not supplied).
The output will be a stereo, fully processed guitar signal complete with speaker
cabinet emulation and reverb.
WINDOWS – The Blackstar Amplification USB Audio Driver is required to work on
Windows. Please download the driver by scanning the following QR code:
or go to:
www.blackstaramps.com/audio-driver-download
MAC - No installation of Audio Drivers are required. Connect your amp directly to
your Mac to use as a plug and play audio interface.
For a guide on low latency USB recording visit:
www.blackstaramps.com/usbrecording
NOTE: Always connect the amplifier via a main USB port, often found on the rear of
the computer. The amplifier will appear as an audio capture device within recording
software.
14. Kensington Lock
Also known as a Kensington Security Slot or K-Slot this is a specifically sized hole
for connecting a compatible Kensington Lock to secure the amplifier to a fixed
point. For more information please refer to www.kensington.com
13
Publicidad
