PICO TC-08 Guia De Inicio Rapido página 7

Quick Start Guide
Temperature
Product
Storage
–20 to 60 °C
ADC-20 & ADC-24
–20 to 80 °C
DrDAQ
–20 to 80 °C
PicoLog 1000 Series
–20 to 80 °C
PicoLog CM3
–20 to 80 °C
PT-104
–20 to 60 °C
TC-08
Product
All data loggers
Some Pico data loggers have enhanced environmental speci昀椀cations. Refer to the device's
User's Guide and Data Sheet for further information.
2.5 Care of the product
The product contains no user-serviceable parts. Repair, servicing and calibration require
specialized test equipment and must only be performed by Pico Technology or an approved
service provider. There may be a charge for these services unless covered by the warranty.
To prevent injury or death, do not use the product if it appears to be damaged in any way, and
stop use immediately if you are concerned by any abnormal operations.
When cleaning the data logger, use a soft cloth and a solution of mild soap or detergent
in water. To prevent electric shock, do not allow water to enter the casing, as this will
compromise the electronics or insulation inside.
To prevent electric shock do not tamper with or disassemble the data logger, case parts,
connectors or accessories.
DO112-10
Humidity
(RH, non­condensing)
Stated
Operating Storage
accuracy
0 to 45 °C 20 to 30 °C
5% to 95%
0 to 70 °C 20 to 30 °C
0% to 95%
0 to 70 °C 20 to 50 °C
5% to 95%
0 to 50 °C 20 to 28 °C
5% to 95%
0 to 70 °C 20 to 30 °C
5% to 95%
0 to 50 °C 20 to 30 °C
5% to 95%
Altitude Pollution degree
2000 m
Pollution degree 2
WARNING
Copyright © 2005–2022 Pico Technology Ltd. All rights reserved.
2.6 Conformance
Operating
5% to 80%
5% to 80%
5% to 80%
20% to 80%
20% to 90%
5% to 80%
General statement of conformity
The enclosed instrument has been calibrated in accordance with the manufacturer's
veri昀椀cation procedure using standards that are traceable to UK national standards. The test
location's quality management system complies with, and its calibration process is controlled
under, ISO 9001:2015. The calibration processes are designed to certify that the instrument
was within its published speci昀椀cation at the time of calibration. The measurements were
made in a monitored environment.
FCC notice
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference which the user will be required to correct at their own expense.
CE & UKCA notices
These USB data loggers meet the intent of the CE EMC directive 2014/30/EU and UKCA
SI 2016/1091 EMC Regulations.
These USB data loggers also meet the intent of the CE Low Voltage Directive 2014/35/EU and
UKCA SI 2016/1101 Electrical Equipment (Safety) Regulations.
USB Data Logger
3