Publicidad
Idiomas disponibles
Idiomas disponibles
Precautions
1.
Warranty card
The serial number is written on the rear panel of this unit.
Copy the serial number and model number onto your war-
ranty card and keep it in a safe place.
2.
Power
WARNING
BEFORE TURNING ON POWER FOR THE FIRST TIME, READ
THE FOLLOWING SECTION CAREFULLY.
e Some models are designed for use only with the power
supply voltage of the region where they are sold.
e European models:
AC 220V, 50Hz
e Canadian models:
AC 120V, 60Hz
e Worldwide models:
AC 120 and 220V
switchable, 50/60Hz
e Voltage selector (rear panel)
Worldwide models are equipped with a voltage selector to
conform with local power supplies. Be sure to set this
switch to match the power supply in your area before turn-
ing the power switch on. Voltage is changed by sliding
the groove in the switch with a screwdriver to the right or
left. Confirm that the switch has been moved all the way
to the right or left before turning the power switch on.
Models without a voltage selector can only be used in
areas where the power supply voltage is the same as that
of the unit.
220V ~\ 120V
220V © 120V ~
at AC 120V
at AC 220V
WORLDWIDE MODELS ONLY
3.
Deck location
4.
Cassettes to avoid:
System connections
bearing
the "Rt" mark
:
fofe of fe
NF
For playback from deck =>
@™@ For recording on deck
Headphone jack
Dynamic type headphones with a rated impedance in the 8 to 200
ohm range are recommended.
Remote control jack
Note:
Do not attempt to connect the RI remote control jack to any
equipment other than an Onkyo component bearing the RI!
mark. Doing so could cause the unit to malfunction.
Notes:
1) DIN terminal supplied on European models only.
2) Do not connect DIN cords and pin cords at the same time.
Publicidad
