Ruhhy N23511 Instrucciones De Operación página 4

MIST/TIME SWITCH:
Tip: When you press the "MIST/TIME" switch for the first time, the aromatherapy machine will default to mist mode. If you press
the "MIST/TIME" switch for 10 seconds, the MID/shingle LED will flash along with its lights and the aromatherapy machine will
enter low mist mode.
1. Press the "MIST/TIME" switch for the first time; the aromatherapy lamp lights and mist will operate continuously.
2. Press the "MIST/TIME" button a second time; the aromatherapy device will operate in a 10-second spray mode
and stops for 10 seconds in "10-second intermittent beeps" mode.
3. Press the "MIST/TIME" switch for the third time; the aromatherapy device will operate on a 2-hour timer
with "2-hour signal" lights.
4. Press the "MIST/TIME" switch for the fourth time; the aromatherapy device operates in a 4-hour timer mode with "4-hour signals"
lights.
5. Press the "MIST/TIME" switch for the fifth time; the aromatherapy machine will stop working.
LIGHT SWITCH:
1. When the aromatherapy machine starts working, the light will change to automatic color cycle mode.
2. When the light is circulating, pressing the "LIGHT" switch will set the system to the current light color.
3. Press the "LIGHT" switch again to select lighting; you can then press: switch to change the color to the appropriate one each time
(seven types of colors; each color has two levels).
4. After viewing all the colors, press the "LIGHT" switch again to close the light.
5. Press the "LIGHT" switch again to return to the seven-color auto cycle mode.
INSTRUCTIONS FOR USE (USE ONLY WATER):
1. Open the cover in the direction of the arrow
2. Add water to the spray chamber
3. Close the cover in the direction of the arrow
4. Connect the power supply shown by the arrow
INSTRUCTIONS FOR USE (USE WITH ESSENTIAL OIL):
1. Turn off the power supply
2. Remove the cover.
3. Add your chosen aromatherapy oil to the atomizing chamber
4. Add appropriate amount of water.
5. Close the cover and turn on the power supply.
ATTENTION:
- When adding water, use the scale mark to add the correct amount. If the amount of water added exceeds or falls on the highest
scale, more or less mist will be sprayed.
- If there is too much water when first added, there will be less steam; after water reduction there will be more steam.