Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continue)
INSTALL WARMING SHELF
1. Install 2x M4x8mm self tapping screws into holes "D" in the bottom of
hood flange leaving 1/8'' gap.
2.
Remove shelf packaging and protective film (if have) • Engage self
tapping screws into the keyhole slots in the top of the shelf. Slide shelf
towards the left to lock into place.
3. Install 2x M4x10mm screws with washers through the bottom of the shelf
into the bottom hood flange locate "E"
INSTALL HOOD ONTO WALL SKIP THIS STEP IF INSTALLING BENEATH
A SOFFIT OR CABINET
INSTALL OUTLET ADAPTER ONTO TOP OF HOOD
Important: Check That Damper Moves Freely
•
Place the outlet adapter (2x) over the hood exhaust and secure with 4x M4x12mm self tapping screws
•
Use duct tape to seal the connection. Check to be sure the damper moves freely.
HANG HOOD ON BACK BRACKET
•
Lift the hood and hold it close to the mounting bracket, Line up mounting holes in "B" position.
•
Make sure the screw head on the bracket is engaging into the keyhole slots on the back of the hood.
•
Slide down the hood to make it hang correctly on the bracket Tighten the screws in the "B" position.
•
Make sure the hood is leveled and certered.8 holes in the "C" position must line up with bracket holes properly.
•
Install 8xM4x8mm self-tapping screws through the back of the hood in the "C" position and tighten to the
mounting bracket.
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
B
C
12
D
D
E
1/8"
Gap
E
Publicidad
