Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INSTRUCTIONS
MAINTENANCE / SERVICE
• Never attempt to disassemble, repair or modify the unit yourself. Otherwise, the warranty becomes void. Repairs by
unqualified persons may result in damage or malfunction. Please contact the nearest authorized service center. The light
source contained in this fixture should only be replaced by the manufacturer or its service agent or a person of equivalent
qualification.
• Screens, lenses or UV filters should be replaced if they are visibly damaged to an extent that compromises their
effectiveness, such as by deep cracks or scratches.
• The lamp should be replaced if it has been damaged or deformed by heat.
• Disconnect the unit from the mains before servicing.
• If the cable or flexible outer cord of this fixture is damaged, it must be replaced with a special cable or cord from the
manufacturer or its service agent only.
• Never immerse the unit in water or any other liquid. Wipe only with a slightly damp cloth.
OPERATION INSTRUCTIONS
1 • Place the unit on a flat surface and in a suitably large area with at least 50 cm of
open space around the unit.
2 • Open the top lid of the water tank.
3 • Fill the water tank with distilled water.
4 • Fill the fluid tank with fog fluid.
5 • Plug the power cord into the outlet and turn on the unit, put the power switch to
the "ON" position. The LCD display will show "WARMING UP". After few seconds
the LCD display will shows "READY".
6 • Using the LCD display panel, set the unit to the desired operating mode.
7 • Turn off the unit, put the power switch to the "OFF" position and pull out the
power cord from the outlet.
6 • Before transporting the unit, empty water tank by connecting a tube to
drainage valves.
BEFORE ADDING LIQUID.
DO NOT OPERATE WITHOUT
LIGHTING FLUID ONLY.
P.14
!
DISCONNECT POWER
LIQUID.
PLEASE USE ALGAM
Publicidad
