C-LITE C-BD-A-PWY Serie Instrucciones De Instalación página 2

INSTALLATION INSTRUCTIONS
C-BD-A-PWY Series
FIGURE 3
ELECTRICAL CONNECTIONS
NOTE: LED driver mus be supplied by an individual properly grounded
branch circuit protected by a 20 ampere circuit breaker.
NOTE:Use Min 75C supply conductors
NOTE: Grounding and bonding of the overall system shall be done in
accordance with NEC Article 600 and local codes.
Fixture is equipped with universal volt driver 120-277V
(ie. 120V, 208V, 240V or 277V)
PHASE TO NEUTRAL WIRING 120/277V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply common to fixture neutral (white) lead.
3. Connect supply Vin to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply L1 (Hot) to fixture neutral (white) lead.
3. Connect supply L2 (Hot) to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no
wires are pinched.
www.e-conolight.com |
Document: LPN05501X0001A0_A
Created By: TMT
CAUTION: Changes or modifications not expressly approved could void
your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-003 (A)/NMB-003 (A)
888.243.9445 | FAX: 262.504.5409
Date
FCC NOTICE
10-4-2023