Publicidad
Idiomas disponibles
Idiomas disponibles
Water Protection
· This product was tested under controlled laboratory conditions, and has a rating of IPX4 under
IEC standard 60529. Sweat and water resistance are not permanent conditions and resistance
might decrease as a result of normal wear.
· Do not use this product near water.
· Do not submerge or expose the products for extended period to water, or wear while
participating in water sports, e.g., swimming, waterskiing, surfing, etc.
· If this product and its accessories are accidentally exposed to water, please wipe it as soon as
possible and place it in a ventilated and cool place for drying. Do not use or charge the product
again until it is completely dry.
· The glasses case is not water-resistant.
Cleaning and Maintenance
· Before cleaning and maintenance, turn off the power of the product and disconnect all
connections and cables from other equipment.
· After each use, wipe both sides of the lenses and all parts of the frame with the cloth bag
provided. Do not use paper tissues or cloths containing fibers derived from wood. Do not use
dirty or abrasive cloths.
· Do not clean your glasses with anything sharp or abrasive. To avoid glasses damage,
deformation, and discoloration, do not use abrasive cleaners or sprays, high-concentration
cleaners, chemical cleaning fluid, alcohol, or acetone solvent to clean your glasses.
· Please do not rinse your glasses directly with water or use ultrasonic cleaning.
Storage
· Keep the product in the cloth bag or case provided during transport and periods when not in use.
· Keep in a dry place at a temperature between -10°C and 35°C.
Regulatory and Legal Information
FCC Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements set a SAR
limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this
standard during product certification for use when properly worn on the head.
Responsible party (contact for FCC matters only):
AfterShokz LLC.
3200 Gracie Kiltz Lane, Suite 400 Austin, TX 78758, The USA.
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s): Operation is
subject to the following Two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
CAN ICES-3(B)/NMB-3(B)
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
www.shokz.com
Publicidad
